
The UK could fall short of its legally binding climate targets if the government relaxes requirements for automakers to increase electric vehicle (EV) sales, according to the independent Climate Change Committee (CCC). The proposed change follows reports that ministers are considering reducing the 2030 EV sales target by around a quarter, to approximately 60 per cent, following a consultation on possible revisions to the Zero-Emission Vehicle (ZEV) Mandate. Participate in AL Circle’s upcoming e-Magazine Smart ALuminium: Advancing Industrial Technologies in 2027 to showcase how advanced technologies drive sustainability across the aluminium value chain. Under the current rules, zero-emission vehicles must account for an increasing share of manufacturers' annual car sales, rising from 33...
Kazakhstan's aluminium exports to the European Union (EU) reached 110,184 tonnes in 2025, generating EUR 274 million in revenue, according to the country's Ministry of Trade and Integration. The EU's share of Kazakhstan's total aluminium exports rose sharply from approximately 6 per cent to 54 per cent, highlighting the growing importance of the European market for the country's aluminium industry. However, the introduction of the European Union's Carbon Border Adjustment Mechanism (CBAM) is bringing new compliance requirements for Kazakh exporters, with carbon accounting, emissions verification and production modernisation emerging as key areas of focus. These challenges were discussed during a session held in Antalya, Türkiye, alongside the 31st Conference of the Parties to the UN...
Grow with
AL Circle

Hero Cycles Ltd today said it will start manufacturing aluminium frames for its sports and luxury bicycles following the setting up of a new assembly unit at Ghaziabad. The company, which has been importing the frames since it forayed into the top-end segment earlier this year, said the new unit has been set up with an investment of Rs 21 crore in Phase I, and will go to about Rs 50 crore in Phase II. It is capable of rolling out 1.2 lakh frames per annum. The new unit has been incorporated in the manufacturing facility of Hero Motors in Ghaziabad, the company said in a statement. “So far Hero Cycles has been importing the aluminium frame which is required to manufacture the high—end/sports bikes. To maintain the precedence of staying ahead of competition all the time, it was imperative...

Gulf Extrusions, one of the largest aluminum extrusion plants in the Gulf region, has witnessed a three-fold increase in its export volumes to the Indian market in the first two quarters of 2012, said a senior official. A part of the Al Ghurair Group of Companies, Gulf Extrusions produces aluminum extruded profiles ranging from architectural sections to components for air conditioning grills, furniture, marine applications, transportation, automotive, and customized products. On the export growth, general manager Modar Al Mekdad said: "The surge in demand in new export markets as well as the consistently strong performance achieved in traditional markets across the Middle East have prompted Gulf Extrusions to boost its production capacity this year." He pointed out that the Indian market...

Fujian Minfa Aluminium Inc. made an announcement about its joint-stock subsidiary on August 10. According to the announcement, Minfa Aluminium Minfa will jointly set up Jiangxi Minfa Technology Co., Ltd with natural persons Huang Jinchao and Wang Xinfa. Minfa will invest 52 Million RMB which occupies 52% of registered capital. The Board of Directors has passed this proposal. The business scope of the joint venture will include: R&D, production and sales of new materials related construction aluminium products; logistics distribution and product display for small and medium-sized enterprises; office and life support. The joint venture will help Minfa to improve its industrial chain and company strategic layout, advance its high-end technology and enhance its profitability.

Stocks of aluminum alloy ingot stored at the London Metal Exchange warehouse in Guangyang of South Korea have dropped to 7,820 mt on August 9, down 39.6% from 12,960 mt on July 9, according to recent LME data. The stocks have dropped mainly due to Japanese buying, fueled by the LME aluminum alloy prices falling by $200/mt in the last four months, South Korean and Japanese trade sources said. Aluminum alloy ingot includes 226-grade used by the Japanese secondary aluminum alloy smelters as feedstock, as well as ADC12 used by diecasters. Trade and secondary aluminum smelter sources said the recent imports into Japan are believed to be mostly of 226-grade. Japanese customs data showed that aluminum alloy imports from South Korea to Japan increased to 2,561 mt during the January-June 2012...

Rio Tinto Alcan has no immediate plans to lift a force majeure on primary aluminum shipments to customers in the Asia Pacific, spokesman Bryan Tucker said late Monday, although quality problems at the Sohar Aluminium joint venture smelter has been brought under control. The smelter is turning out 100% on-spec material, and currently running its 365,000 mt/year facility at full capacity, Sohar spokeswoman Lisa Christowitz told Platts at the weekend. Rio Tinto Alcan on July 19 declared force majeure on supplies of P1020 standard 99.7% aluminum ingot to all customers in Asia, citing quality issues at Sohar. According to sources, Rio Tinto Alcan explained in a letter to customers that the breakdown of certain critical plant equipment had made it difficult for Sohar to control deviations in...

According to the data of China Custom that China imported 460 thousand tons of alumina in July 2012, from January to July imported 2,930 thousand tons totally increased 172.0% yoy. The import volume of unwrought aluminum and aluminum products was 97,651 tons, from January to July imported 711,363 tons increased 34.0% yoy. As to the aluminum scrap has imported 230 thousand tons in July, 1460 thousand tons from January to July totally, decreased 1.2% yoy. At the same time, China exported 54,051 tons of unwrought aluminum in July, totally 396,158 tons from January to July also decreased 8.0% yoy.

The federal opposition says the carbon tax is partly responsible for 90 job losses at Australia's largest aluminium smelter in Queensland. Opposition industry spokeswoman Sophie Mirabella says an organisation restructure, as well as a blow-out in operating costs, taxes and over-regulation has hit Boyne Smelters hard. "With the industry operating on such small profit margins, it's no surprise that the added expense of the carbon tax is the last straw for many businesses," she said in a statement. Boyne Smelters, near Gladstone in central Queensland, has a production capacity of 545,000 tonnes of aluminium per year and employs 1500 people. It is 59 per cent owned by Rio Tinto. It is the second Rio Tinto project in Queensland revealed as being under pressure in a week. Rio Tinto announced...

Most Asian equities traded lower on Monday as the result of a dearth of major global data points over the weekend. On Chinese exchanges, Aluminum Corp. of China (ACH, quote) was no exception, leading shares in Hong Kong (EWH, quote) downwards. Both Hong Kong and Mainland Chinese indices (FXI, quote) traded lower on Monday. The Shanghai Composite was the biggest mover to the downside, falling almost a percent. Hong Kong followed its norther neighbor’s lead, dropping a third of a percent. Chinese exchanges were adversely affected due to the lack of news over the weekend; traders were hoping that Beijing would announce new plans to stimulate the economy. However with the government not announcing any new measures, many stocks performed poorly. ACH was one such stock. Its poor performance...

National Aluminium Company (NALCO) is set to declare its results for the quarter ended June 2012 on Tuesday. Analysts on an average expect the profit after tax to fall by 38% year-on-year and 17% quarter-on-quarter to Rs 234.3 crore. Net sales are expected to be flat at Rs 1,740 crore during the quarter as against Rs 1,733 crore in a year ago period and Rs 1,753.4 crore in the previous quarter. Earnings before interest, tax, depreciation and amortisation (EBITDA) are seen gong down by 39% YoY to Rs 304.3 crore, but quarter-on-quarter the same is likely to rise by 10%. EBITDA margin is expected to be at 17.5% as against 28.9% in the corresponding quarter of last fiscal and 15.7% in the previous quarter. In the fourth quarter of financial year 2011-12, the profit after tax had included more...

Chalco’s $925-million (U.S.) offer for a 60 per cent stake in SouthGobi in April produced an unfriendly response: a new investment law limiting foreign companies to 49 per cent ownership of mines. More insidiously, Mongolia has dragged its feet over renewing some of SouthGobi’s licences, scaring away customers and squashing production. SouthGobi’s shares now trade at less than half the value of Chalco’s April approach, which stands until September. Mongolia has picked some hefty targets. Rio Tinto indirectly holds a controlling stake in SouthGobi, through its controlling position in Toronto-listed Turquoise Hill. China Investment Corp. also owns 13 per cent of SouthGobi, bought at around the level of Chinalco’s bid. Mongolia’s protectionism looks short-sighted, but its opponents are...

The slowing global economy dashed hopes for consumption growth. Coupled with stronger risk aversion overnight, LME aluminum extended losses for a fourth straight trading day and dipped to a low of USD 1,855/mt. Total positions were up 4,345 lots to 711,584 lots. As shorts dominated, LME aluminum was deprived of any rising momentum at the tail of trading. Finally, LME aluminum ended the day down USD 20.5/mt or 1.09% to a near intraday low of USD 1,856.5/mt. Latest LME aluminum inventories were up 6,775 mt to 4,867,725 mt. Aluminum prices are facing downward risks due to a lack of positive news. LME aluminum should continue to test support at USD 1,850/mt and move between USD 1,845-1,875/mt on Tuesday. The most active SHFE 1211 aluminum contract is expected to open lower at near RMB...

The bauxite mining operation in Mali Hill in south Odisha’s Koraput district by Hindalco Industries has been stopped due to the agitation by the local tribal people. Taking up cudgels under the banner of Mali Parvata Surakhya Samiti (MPSS), the tribal people of the area have launched an agitation demanding cancellation of mining lease issued to the aluminium major. The agitators pointed out that tribals of around 40 villages under the Sorishapodar, Hundi, Dalaiguda and Pakhajhola panchayats in Similiguda block would be affected by the mining operation. “We demand immediate cancellation of the mining lease granted to the company,” said Damburudhara Khillo, president of MPSS. He alleged that the water sources, on which the local people are dependent for their survival, would dry up if the...

Haomei Aluminium announces recently that it has successfully developed a new type of aluminium profile and has used it to forge entire car frame. Seen from the current R&D result, this new aluminium car frame can reduce 15% of the car weight. As the weight is reduced, the car’s brake performance increases by 5% which can absorb more crash energy compared with steel. The new aluminium car frame can also reduce the car’s carbon emission by 20% and increase mileage per liter by 10%. Haomei Aluminium is a high-tech enterprise specializes in research and development, manufacturing and sales of all kinds of construction aluminium profiles and industrial profiles. Haomei has established research cooperation with South China University of Technology, University of Science and Technology of China,...

Bronx International has recently commissioned and received final acceptance of its latest Coil Coating Line at ALO Aluminium in Nigeria. The Bronx Color Coating Line is the second Bronx line installed for ALO Aluminium to keep up with market demand for their quality color coated sheets. Bronx's initial color coating line was installed in 2000 and Bronx has since proudly supported ALO Aluminium as it grew and expanded since that time. ALO Aluminium manufacturing company (Nigeria) Limited has gradually become a household name in the Aluminium roofing industry. Since its inception on September 12th 1990, the company has carefully studied the Nigerian situation and has come up with products and ideas that are calculated to meet with the rising level of customer sophistication in the roofing...

The Aluminum Extruders Council (AEC), the Aluminum Association, and the Aluminum Anodizers Council (AAC) have released the program details for Aluminum Week 2012 in Chicago, Illinois. This event marks the third year of cooperation between the organizations to offer a program featuring comprehensive education and networking opportunities for aluminum industry professionals. Aluminum Week will be hosted at the Renaissance Downtown Chicago from Monday, October 15 to Thursday, October 18, 2012. The co-located event features The Aluminum Association’s Annual Meeting, the Aluminum Extruders Council’s Management Conference and the Aluminum Anodizers Council’s 21st Annual International Anodizing Conference. The week-long event is composed of programming focused on “The Road Ahead”, addressing...

Rio Tinto Alcan has offered more flexible licensing terms for rivals to end an antitrust investigation and avert a possible fine, EU regulators said on Friday as they sought feedback from competitors on the proposals. The European Commission said it had been investigating the issue following a 2008 merger which created Rio Tinto Alcan, a unit of Anglo-Australian mining company Rio Tinto. The EU antitrust watchdog said it was concerned Rio Tinto Alcan's practice of contractually tying the licences of its AP aluminium smelting technology to the purchase of aluminium smelter equipment supplied by a subsidiary may have breached EU rules. AP aluminium smelting technology reduces energy consumption in aluminium production. "To address these concerns, Rio Tinto Alcan offered to modify its AP...

China's exports of finished aluminium products are expected to rise in August, slightly boosting aluminium ingot demand. But this should not be taken as a sign that global aluminium demand has picked up as these exporters are selling at thin and sometimes even negative profit margins due to the unfavourable price arbitrage, consultancy Shanghai Metals Market said in a recent note. Chinese aluminium foil producers are selling into the Middle East and North America markets to avoid a complete shutdown of their plants. "This will cause production of aluminium foil to spike in August," SMM added.

IFC, a member of the World Bank Group, has arranged a €45 million financing package for the Alutech Group, the largest private manufacturer of aluminum products in Belarus, to support the company’s growth and expansion of exports. IFC provided a €25 million loan from its own account and mobilized another €20 million from Priorbank, a leading commercial bank in Belarus and a member of RZB Group. This is IFC’s second investment in Alutech. “We are facing a growing regional market and opportunities in Europe,” said Alexei Zhukov, general director of the Alutech Group. “IFC’s financing will help us finance construction of a new production plant, consolidate positions in Belarus, Russia, and Ukraine, and expand into new markets.” Alutech aluminum products are widely used in industrial,...