
The UK could fall short of its legally binding climate targets if the government relaxes requirements for automakers to increase electric vehicle (EV) sales, according to the independent Climate Change Committee (CCC). The proposed change follows reports that ministers are considering reducing the 2030 EV sales target by around a quarter, to approximately 60 per cent, following a consultation on possible revisions to the Zero-Emission Vehicle (ZEV) Mandate. Participate in AL Circle’s upcoming e-Magazine Smart ALuminium: Advancing Industrial Technologies in 2027 to showcase how advanced technologies drive sustainability across the aluminium value chain. Under the current rules, zero-emission vehicles must account for an increasing share of manufacturers' annual car sales, rising from 33...
Kazakhstan's aluminium exports to the European Union (EU) reached 110,184 tonnes in 2025, generating EUR 274 million in revenue, according to the country's Ministry of Trade and Integration. The EU's share of Kazakhstan's total aluminium exports rose sharply from approximately 6 per cent to 54 per cent, highlighting the growing importance of the European market for the country's aluminium industry. However, the introduction of the European Union's Carbon Border Adjustment Mechanism (CBAM) is bringing new compliance requirements for Kazakh exporters, with carbon accounting, emissions verification and production modernisation emerging as key areas of focus. These challenges were discussed during a session held in Antalya, Türkiye, alongside the 31st Conference of the Parties to the UN...
Grow with
AL Circle

A $30 million Tomago cable factory has won state government approval. The NSW Planning decision paves the way for Bahrain-based Midal Cables to forge ahead with a new plant on the eastern edge of the existing Tomago Aluminium site. The new project could be a substantial boost for the region’s aluminium sector, which has suffered significant job losses already this year. When operational, the Midal plant will allow the cables to be made from hot metal direct from the smelter. The proximity to Tomago Aluminium will also remove the need to cool or cast the resource before it is recast into products. The Newcastle Herald reported last year that about 50,000 tonnes or a tenth of Tomago Aluminium’s output could be made into rods and conductors under Midal’s full capacity.

ABB has secured a $9m contract to oversee maintenance procedures at a rolling mill of the Oman Aluminium Rolling Company (OARC) at the eventual site of the company’s facility in Sohar. The Greenfield Aluminium Rolling Mill will produce flat sheet and aluminium foil and have a capacity of 140,000 tonnes a year. The primary markets for the product will be the Middle East and Europe, with the projected completion date likely to be sometime in the third quarter of 2013, when operations are due to commence. ABB will develop, implement and execute all maintenance activities at the rolling mill.

Norsk Hydro ASA (NHY), Europe’s third- largest aluminum maker, is cutting capacity at plants where it uses third-party metal to make orders for the auto and building industries after suffering losses. The company will shut 35,000 metric tons of remelting capacity at its Sunndal plant in Norway and is considering plans to curtail about 120,000 tons of capacity at its Aardal plant, company spokesman Halvor Molland said by phone today. It will increase primary aluminum production at Sunndal. Hydro, which is seeking to reduce the cost of aluminum production by $300 a ton, has been cutting production at non- profitable plants this year. In July, the company said it would close its 180,000 ton-capacity Kurri Kurri smelter in Australia. Hydro began talks with unions and management at Aardal...

The cash price of primary aluminum experienced the biggest price decline of the day, dropping 1.2 percent on the LME to close at $1,820 per metric ton on August 3, 2012. Also on the LME, the aluminum 3-month price fell 1.2 percent to $1,854 per metric ton. Meanwhile, the Indian aluminum cash price weakened by 0.2 percent. Chinese aluminum closed mixed last Friday. Chinese aluminum billet ended the day after a 0.3 percent drop last Friday. The cash price of Chinese aluminum declined 0.3 percent as well. The price of Chinese aluminum scrap held steady above $2,000 per metric ton, and the price of Chinese aluminum bar saw little movement last Friday.

After taking several recent hits the Hunter's aluminium sector has received a boost with a $30 million manufacturing facility approved near Newcastle. Bahrain based company Midal Cables International has received State Government approval to build the Tomago facility with an Australian-based partner next to the Tomago aluminium smelter. It will use molten aluminium from the smelter to make rods, wires and conductors. The company says the project will create 250 immediate jobs and there will be plans to further boost the workforce in the coming years. At full capacity Midal's facility will be able to produce 50,000 aluminium rods and conductors annually for a range of industries including power transmission and distribution. The aluminium sector is still reeling after the Tomago smelter...

The government plans to invest up to Rp 12 trillion ($1.3 billion) in Indonesia Asahan Aluminium, which engages in smelting and producing aluminum, in order to boost its output and prepare the company for an initial public offering, a top minister said. Hatta Rajasa, Indonesia’s chief economic minister, reaffirmed on Friday the government’s intention to fully control the company known as Inalum. That will take place once a contract drawn up in 1975, which gave Japanese consortium Nippon Asahan Alumunium a 58.88 percent stake in the company, ends on Oct. 31, 2013. The government, which currently owns the remaining 41.12 percent stake, has the right to purchase Nippon Asahan’s entire holding. Officials have cited the aluminum smelting industry’s key role in the economy, especially amid...

Bauxite Resources Ltd (BRL) chief executive Scott Donaldson presented his company's case for a local bauxite venture to the Bridgetown-Greenbushes Shire Council meeting last week. Mr Donaldson told council he was disturbed by scare-mongering and wished to debunk myths. He said his company only has a minority stake in the Bauxite Alumina Joint Venture, which is working toward setting up a refinery in WA - but he said it was premature to talk about the location of the refinery. The Joint Venture group hopes to secure an annual target of 90 million tonnes of bauxite and only when this was the case would a refinery be considered. "Until there are resources (bauxite) there will be no refinery," Mr Donaldson said. Manjimup Shire president Wade De Campo said he hoped a bauxite refinery would be...

The global demand for bauxite, from which the aluminium smelter feedstock alumina is derived, is likely to rise at an annual rate of 6.9 per cent from 220 million tonnes (mt) in 2011 to 750 mt in 2030. The world is richly endowed with bauxite mineral, distributed across all continents. And, a good portion of that is in the “proved” category. Even then alumina refineries across the world making do with procurement of bauxite from the market have started experiencing supply constraints. Concerns about shrinking availability of bauxite got heightened when under a new mineral policy, Indonesia slapped an export duty of about 20 per cent on 65 minerals. More ominously, Jakarta has ordained that starting 2014, there will be a ban on exports of bauxite and 13 other minerals so that whatever goes...

Market confidence was greatly boosted, as markets were digesting the positive US nonfarm payrolls and as the big drop of bond yields of Spain and Italy helped cut borrowing costs in the two countries. The US dollar index tested support at 82, pushing LME aluminum to rebound. LME aluminum broke through the 5-day and 10-day moving average to a high of USD 1,884/mt during the European trading session, leading gains of all base metals. However, trading volumes contracted, limiting its upward momentum due to cautious responses from the longs. LME aluminum finally closed at USD 1,877.3/mt, up USD 19.3/mt or 1.04%. Latest LME aluminum inventories were up 15,975 mt to 4,880,425 mt. The US dollar index hovering at the low end will support aluminum prices. LME aluminum should test resistance at USD...

Apple’s earliest iPhone prototypes were unearthed during the trial between Apple and Samsung last week, and further investigation into older court filings from the case have revealed some of the reasons behind Apple’s decisions for the design of its smartphone. Networkworld’s Yoni Heisler reports that Samsung’s attorney has questioned former Industrial Design Creative Lead at Apple, Douglas Satzger, who is now the Vice President of Industrial Design at Intel. Satzger worked on the original iPhone, the iPhone 3G and the iPhone 3GS. Satzger told Samsung’s attorney that Apple’s industrial design team had a strong interest in developing an iPhone with shaped glass on both the front and the back of the device. The reason Apple decided against this design for the iPhone was because it would be...

Aleris will announce second quarter 2012 earnings on Thursday, August 2, 2012. The Company will host a conference call that day at 9 a.m. Eastern Time to discuss earnings results. The call can be accessed by dialing 1-877-398-9483 or 1-760-298-5072 (for international callers) -- and referencing ID #12139726 - or through the Company's website, www.aleris.com. A replay of the call will be available later that day on the Company's website in the Investor Relations section. Aleris is focused on realizing the significant potential of aluminum for our customers and our world. A global leader in aluminum rolled and extruded products, aluminum recycling and specification alloy manufacturing, Aleris products are used by manufacturers in almost every industry. Headquartered in Cleveland, Ohio, the...

Norwegian aluminium firm Norsk Hydro has agreed to sell its Portalex extrusion plant in Cacem, Portugal, to Germany's Bavaria Industriekapital AG for an undisclosed sum, the company said on Wednesday. The transaction is expected to close on Aug. 31, Hydro said, adding that the plant, which handles extrusion and product finishing, employs about 170 people. "Portalex, as the company is known in the market, has felt the downturn in the Portuguese market and struggled over the last years," Hydro said.

Hydro is making adjustments to the structure of its aluminum extrusion network in the United States. The company has today announced that it will cease extrusion operations at its facility in Missouri, and that it will bring new fabrication activities to its plant in Arizona. The Monett-based plant, located in the southwest part of Missouri, was built in 1964 and acquired by Hydro in 2000. Profitability at the extrusion site has been an issue for many years, despite internal improvements, and demand in its key market segment – building and construction – has been soft and remains uncertain. Matthew Dionne, president of Hydro’s North American aluminum extrusion business, says the company explored divestment of the plant before deciding to close the extrusion and fabrication activities....

The decision on whether or not people will wind up helping to foot the bill for a Jackson County business is in the hands of the Public Service Commission. The PSC wrapped up its evidentiary hearings with Century Aluminum on Wednesday. The hearings ended on an emotional note for the Century Aluminum retirees, whose health care benefits are tied to this power agreement. Century retiree Karen Gorrell got the last word before the PSC adjourned. She said, "I'm asking you, as a West Virginia citizen, and as a lawyer, a taxpayer whoever, take that hit. Let's put this together. Get the plant open. Let's join hands together and watch that parking lot fill up. Thank you." Gorrell said their position hasn't changed. The retirees want their health benefits back. They want Century to reopen the...

On Aug. 1, 2012, the day’s biggest mover on our daily aluminum index was the cash price of primary Indian aluminum, which saw a 1.6 percent decline. After a 0.7 percent increase, the 3-month price of aluminum finished the day on the LME at $1,900 per metric ton. Also on the LME, the primary aluminum cash price increased 0.6 percent to $1,862 per metric ton. Chinese aluminum prices were mixed for the day. Wednesday saw the price of Chinese aluminum billet drift down 0.3 percent; the Chinese aluminum cash price did the same. Chinese aluminum scrap held its value on Wednesday at above $2,000 per metric ton. The price of Chinese aluminum bar saw little movement, holding above $2,200 per metric ton as well.

The government is set to take full control over aluminum producer PT Indonesia Asahan Aluminium (Inalum) and then float the company on the stock market or offer it to investors after the acquisition, Industry Minister MS Hidayat said in Jakarta on Friday. Hidayat said that official deliberations for the acquisition of the Japanese consortium’s shares in the aluminum producer would be carried out between August and September this year. “The official takeover signing is expected to take place in October. Afterwards, we are going to carry out a transition period until 2013,” Hidayat said. Hidayat said the state, through the Finance Ministry, would prepare Rp 7 trillion (US$742 million) in funds to complete the takeover. “As of now, Rp 2 trillion is available, while another Rp 5 trillion will...

Alcoa Inc said on Thursday it won a contract to supply drill pipe made of an aluminum alloy to Pennsylvania General Energy, which operates natural gas wells in the Marcellus Shale formation of Pennsylvania. The use of aluminum instead of steel, which is more common for drill pipe, will allow PGE to drill deeper and will also require less energy, the drilling company said. The announcement highlights the growing use of aluminum and aluminum alloys as a substitute for steel. Aircraft and motor vehicle manufacturers are using more aluminum, as it is as strong as steel but lighter. Alcoa said it will produce 3,500 feet of 4.5 inch drill pipe for PGE, which will allow it to extend the reach of drilling rigs on natural gas wells to about 7,500 feet. That is 1,000 feet deeper than conventional...

VHE has successfully commissioned a stub straightening machine supplied to the ALRO aluminium smelter in Romania. The machine has been designed for the 2x2 130mm stub diameter techonology in use at ALRO and completed the Performance Acceptance Test on 31 July 2012. Inward bending of anode stubs, generally known as "toe-in", is a well understood occurrence in all pre-bake aluminium smelters. The difference in linear expansion of the carbon anode and the steel yoke or spider of the anode rod at high temperatures in the reduction cell means that the yoke expands more than the anode, bending the stubs which are anchored in the anode block. Stubs become bent inwards just above the iron thimble, changing the geometry of the yoke, and stubs can no longer be correcly located in the anode holes...