We use cookies from our users to operate this website and to improve its usability. You can find details of what cookies are, why we use them and how you can manage them in our Cookies page. Please note that by using this site you are consenting to the use of cookies.

Do not show me this message again Close

Menu
Downstream Products - Industry Reports
Free The Research on Development and Application of Contact type Shape Meter

Flatness, apparently, describes the strip warpage which is produced during rollingprocess. It is expressed by relative length generally. Internally, it reflects the residualstress distribution. Flatness is an important parameter on cold rolled product quality. It not onlyinfluen ...

Posted On : 18/Jul/2016
Free Numerical Simulation of Extrusion Process and Optimization of Process Parameters for 6061Al Alloy

More uniform strain and temperature could achieved with lower extrusion temperature and higher extrusion speedDepth of deflector should be appropriate ,neither too small nor too large.Shorter die bearing is better than longer one when die bearing is equal on both side.Die bearing ...

Posted On : 18/Jul/2016
Free Aluminum hot top casting for hollow billet

As one of the aluminium fabrication products, aluminium pipe is widely used in military civilian fields with highly added value;At present, most processing enterprise still use the vertical semi-continuous casting method to produce hollow billet,which would cause bad surface qual ...

Posted On : 18/Jul/2016
Free Study of hot deformation behavior of 6016 aluminum alloy

The processing map of 6016 aluminum alloy at different temperature and strain rate is established. In hot rough rolling, the flow instability appears in the condition of 450?~465?,5s-1~15s-1. The applicable open rolling temperature of hot rough rolling is 465?~550?, and the strai ...

Posted On : 18/Jul/2016
Free Effect of composition and natural ageing on the mechanical properties of 6xxx alloys

1.With natural ageing proceeds, the strength of 6xxx alloy increases, while the elongation decreases. The decrease in the elongation is due to the depletion of solutes in the matrix, which deteriorates the work hardening capability.2.The alloys with high Mg or Si content show a s ...

Posted On : 18/Jul/2016
Free Study on composition optimization of 7N01 aluminium alloy

Introduction 1) Since the 1980s, aluminum alloy used in transportation alreadydraws a lot of attention and preference.2) In industrialized countries, more than 30 percent of totalconsumption of aluminum alloy is used in transportation .3) Study on aluminum alloy used in transpor ...

Posted On : 18/Jul/2016
Free Analysis of Shape Aim Curve Setup for Aluminum Strip Cold Mill

In shape aim curve setup, setup value contains twoneeded shape type, ? and ?, excluding irregular shapepatterns. In application of aim shape curve setup, automatic shape control system adjust shape control facilities, ensuring detected shape value equal to aim value, and offline ...

Posted On : 14/Jun/2016
Free Influence of wiper height on 7055 slabs

This paper discusses about the applications of the Influence of wiper height on 7055 aluminium alloy slabs.

Posted On : 10/Jun/2016
Free New insights into the formation of composite precipitates in AA2014 by atom probe microscopy

Applications of aluminium • Strength, ductility, fracture toughness etc• Alloying element addition is essential for Al alloys to have desired properties

Posted On : 09/Jun/2016
Free New insights into the formation of composite precipitates in AA2014 by atom probe microscopy

Applications of aluminium • Strength, ductility, fracture toughness etc• Alloying element addition is essential for Al alloys to have desired properties

Posted On : 09/Jun/2016